Tutriol HWK CHip error 45 FIXED by AVATOR BOX[step by step procedure]

[You must be registered and logged in to see this image.] HWK CHip error 45 FIXED by AVATOR BOX[step by step procedure]

Here is the pin out guide na sinundan namin..

[You must be registered and logged in to see this image.]

- Pinahinang ko sa kanya.

[You must be registered and logged in to see this image.]

- Then after that sinaksak ko na sya sa avator.

- SET PINOUTS. From Avator SW, click PINOUT.
[You must be registered and logged in to see this image.]

*At eto step by step procedure sa hwk repair ver 2.0.0

- run *quot;Avator!! HWK Repair.exe*quot;

- Click on setting and do select setting as shown
*quot;Avator!! HWK Repair ver 2.0.0 CONFIG*quot; then press ok
[You must be registered and logged in to see this image.]

- Select MSP430F11X1

- Click on erase

- Then open the file *quot;AVATOR_REPAIR_HWK_3.08 HWL Flash File.bin*quot; and click on prog

SEE SCREENSHOTS:
[You must be registered and logged in to see this image.]

- After that assemble.. Put HWK cip on the HWK Box. Connect usb and install drivers.

- Tried to run DCTxBB5 but error is like this:
[You must be registered and logged in to see this image.]

- So i decied to UPDATE
[You must be registered and logged in to see this image.]

SUCCESS UPDATE:
[You must be registered and logged in to see this image.]

- Tried to run the DCTxBB5 again if success, but it goes like this:
[You must be registered and logged in to see this image.]

I use other PC and intall the Support suite and the main suite

- Finally, i tried to run DCTxBB5, and here it goes, SUCCESS!!!
[You must be registered and logged in to see this image.]